Home · Solutions · Peak shaving Malaysia
Use case

Peak shaving in Malaysia

Peak shaving in Malaysia targets one short surge. A plastics plant runs steady most of the day, until the extruders and presses fire together and demand jumps by a third for twenty minutes. TNB bills the whole month on those twenty minutes.

Plastics & extrusionMetal & machiningRubber & moulding
The situation

Representative site · Plastics extrusion, Klang Valley

Picture a mid-size injection-moulding and extrusion plant in the Klang Valley. For most of the day it draws a steady ~480 kW. But when a shift starts and the heaters, hydraulics and chillers come on together, demand briefly spikes to around 750 kW. That coincident surge lasts minutes — yet it sets the Maximum Demand for the entire billing month.

What it costs today

One twenty-minute surge, billed all month

Because TNB sets Maximum Demand from the single highest 30-minute interval in the peak window, the 750 kW peak is charged in full, every kilowatt, every month, even though the plant only touches it briefly. At RM 97.06/kW, one surge carries a heavy fixed line on every bill.

RM 72,795 / mo

750 kW × RM 97.06/kW — the demand charge set by a few minutes of surge. Representative, based on the TNB RP4 tariff.

How UniBess solves it

Peak shaving with a BESS leaves the plant running as it does today. The battery absorbs the surge so the meter never records it.

1

Learn the load

We study a year of half-hourly data to find a demand ceiling the battery can defend — here, around 620 kW.

2

Cap every surge

When the shift-start surge pushes toward the ceiling, the BESS discharges within milliseconds to cover the difference. The meter sees 620 kW, not 750.

3

Refill off-peak

Overnight the battery recharges at the off-peak rate, ready for the next day. No operator involvement.

The outcome

130 kW shaved, every billing cycle

Same production, same schedule — only the metered peak changes. The demand charge falls by the shaved kilowatts, and because it’s a fixed rate, the saving repeats every single month.

Without a battery
  • Metered demand: 750 kW
  • Demand charge: RM 72,795 / mo
  • Set by a few minutes of surge
With UniBess
  • Metered demand: ~620 kW
  • Demand charge: ~RM 60,177 / mo
  • Surge absorbed by the battery
≈ RM 12,600 saved / month ≈ RM 151,000 a year, captured every cycle. Representative figures based on the TNB RP4 tariff — we model your real data before quoting.

Is this your site?

Peak shaving in Malaysia pays hardest where demand is spiky, not flat. You’ll likely benefit if:

  • Your metered peak sits well above your average daytime load.
  • Heavy equipment starts together — presses, extruders, compressors, large motors.
  • Maximum Demand is a big, stubborn line on your TNB bill.
  • Your peaks are short — minutes, not hours.

Where we're honest

Peak shaving needs honest data, not optimism. If your interval history doesn’t show a clean, defendable ceiling, we’ll tell you — an undersized battery that misses one surge still pays the higher demand charge for the whole month.